Note endcap freewheel

tune Updated by tune

Important note on changing the freewheel

When changing the freewheel standard, e.g. from Sram XDR to Shimano Microspline, the end cap on the drive side must also be replaced! After changing the freewheel and end cap, it is necessary to adjust the hub again!

The following image shows the different endcaps for the drive side:

Hinweis Freilauf Endkappen

We carry the following endcaps:

  1. QR5 endcap for 10-speed (Hg10) and XD freehubs - Overall length: 16,1mm, Inner depth: 9,2mm
  2. QR5 endcap for 11-speed (Hg11), XDR and Campagnolo freehubs (groove on the endcap used for identification) - Overall length: 16,4mm, Inner depth: 8,5mm
  3. QR5 endcap for MicroSpline and N3W - Overall length: 20,35mm, Inner depth: 12,45mm
  4. 12mm endcap for 10-speed (Hg10) and XD freehubs - Overall length: 15mm, Inner depth: 8,9mm
  5. 12mm endcap for 11-speed (Hg11), XDR and Campagnolo freehubs (groove on the endcap used for identification) -
    Overall length: 15mm, Inner depth: 7,9mm
  6. 12mm endcap for MicroSpline and N3W - Overall length: 19,55mm, Inner depth: 12,45mm

To carry out maintenance work, follow the following instructions:

How did we do?

Hubs front & rear

Contact